Raven Envizio Pro Informacje Techniczne Pobierz pdf (Strona 15)

Operation

During a job, the AutoBoom™ Status Indicator will be displayed on the Envizio

Pro Guidance screen.

This area may display the following indicators for the current status of the

AutoBoom™ system:

Status of the center rack is only displayed if a Glide Series AutoBoom system

capable of controlling the center section is connected to the Envizio Pro console.

Touch the displayed status icon to access the Glide Series AutoBoom™

Calibration screen.

Troubleshooting

The following are a few general tips for troubleshooting the Envizio Pro system.

Refer to the Envizio Pro Installation & Operation manual for detailed

troubleshooting information.

Issue Possible Cause Solution

CANbus cannot

read the Product

Node

• CANbus ends

not terminated

• Make sure that both ends of the CANbus

system are properly terminated. Refer to

the Envizio Pro Installation & Operation

manual for more information.

• Corroded pins

in CANbus

connections

• Check CANbus cable connectors for any

highly corroded pins.

• Ensure dielectric grease has been

applied to all cable connections exposed

to weather and field conditions.

• Moisture in

connection

• Check CANbus cable connectors for any

corroded pins.

• Ensure dielectric grease has been

applied to all cable connections exposed

to weather and field conditions.

• Connectors

not seated

properly

• Check that all CANbus cable connectors

are inserted fully (until the locking tab is

engaged).

• Be sure to remove any moisture in

connections which were not properly

seated. Check for corroded pins and

apply dielectric grease when

reconnecting CANbus cables.

Disabled Off Left/Right

Enabled

Both

Enabled

Center Rack

Enabled

1 2 ... 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Raven Envizio Pro Informacje Techniczne Strona 15

Komentarze do niniejszej Instrukcji